using generic methods and delegates

... anonymous methods are actually quite useful There might well be occassions when you have a block of code that you are never going to call directly, but you would like to be able to invoke using a ... adapter methods in an application—they start to clutter up the classes You can use an anonymous method anywhere that you can use a delegate You simply provide the code, enclosed in curly braces, and ... delegate, like this: control.Add(delegate { folder.StopFolding(0); } ); Features of Anonymous Methods Anonymous methods have several idiosyncracies that you should be aware of They include the following:...

Ngày tải lên: 26/01/2014, 12:20

... transfer, subscripts F and P indicate system fuel and system product, respectively, NK is the number of system components, and NP and NF are the numbers of system products and fuels, respectively ... used, and their minimum and maximum allowable values In problem OP11, in addition to the evident consideration of the turbines and HRSGs, some decision variables associated with the condenser and ... function OF is the same, and the process steam and process hot water demands are assumed constant Here, the larger problem OP11 is considered for both mathematical optimization and exergoeconomic improvement...

Ngày tải lên: 05/09/2013, 16:30

... (Davidov and Rappoport, 2006; Widdows and Dorow, 2002) and meronymy (Berland and Charniak, 1999; Girju et al., 2006) Since named entities are very important in NLP, many studies define and discover ... 2004), meronymy (Berland and Charniak, 1999; Girju et al., 2006), synonymy (Widdows and Dorow, 2002; Davidov and Rappoport, 2006), and verb strength + verb happensbefore (Chklovski and Pantel, 2004) ... related work, and Section presents the pattern clustering and labeling algorithm Section describes the corpora we used and the algorithm’s parameters in detail Sections and Turney and Littman (2005)...

Ngày tải lên: 23/03/2014, 17:20

Ngày tải lên: 08/04/2014, 10:26

... Stx2, eaeA, and hlyA genes, and by flagellar H7 PCR After identification by motility and agglutination tests Table The detection rates of E coli O157:H7 by three different methods Methods Positive ... P010726-22, P010726-23, P010726-25, and O157-C-1-2), and 14 USA isolates; strains of ATCC (A1, A2, A3, and A4), strains of Cornell University (C1, C2, C3, C4, C5, and C6), and strains of Pennsylvania ... (18.2%), and tetracycline (18.2%), respectively (Table 4) Discussion This study was conducted to determine the prevalence of STEC in cattle, pigs, and chickens using different detection methods and...

Ngày tải lên: 07/08/2014, 18:21

... approaches to analyze and rationally interpret the amount of data produced in highthroughput screens Here we describe methods and software to fulfill these requirements Results and discussion We ... morphologic parameters and two fluorescence intensities The morphologic parameters are forward light scatter (FSC) and sideward light scatter (SSC), and they measure cell size and cell granularity ... cells using the morphologic properties provided by the FSC and SSC parameters The joint distribution of FSC and SSC for transformed mammalian cells typically exhibits an elliptical shape, and most...

Ngày tải lên: 14/08/2014, 17:22

... vibration data The classification methods can be divided into three groups: signal processing based methods, model based methods, and FFT based methods The FFT based methods are relied on the following ... Current Signature Analysis) method, the vibration-based methods, etc The purpose of these methods is to detect and diagnose faults in an early stage and therefore allow contingency plans to be put into ... signals and FFT spectrum, (a) normal, and (b) defective bearing Fig Frequency domain and time domain vibration signals of a rotor unbalance case in three directions Fig Frequency domain and time...

Ngày tải lên: 13/11/2014, 06:43

... bead and purified using PAGE DNA libraries consist of oligonucleotides with a constant region of about 20 bp at both the 5’ and 3’ ends and a 20-50 bp randomized region in the middle Shorter random ... mfold software using 100mM NaCl and 10mM MgCl2 for the ionic conditions 160 Figure a.4 Secondary structures of Lep and Lep 4T aptamer, analyzed on mfold software using 100mM NaCl and 10mM MgCl2 ... of aptamers CAT 1-4 using both the NECEEM and fluorescence intensity methods 80 Table 4.4 Binding affinities of lysozyme, trypsinogen, chymotrypsinogen A and myoglobin using fluorescence...

Ngày tải lên: 10/09/2015, 09:22

... Bearing and raceway wear and tear present initially as general roughness and progresses to metal fatigue, and ultimately spall and chip on the surface of the rolling elements [93] Figure 2.4 and ... energy, magnetic energy, operational thermal stress and harsh environmental conditions e.g., humidity and chemical corrosion, causing wear and tear, and ultimately numerous types of fault may develop ... diagnostic scheme, and the rationale for condition monitoring using MCSA and vibration analysis, and sets the stage for stating the objectives of this research Fault statistics and literature survey...

Ngày tải lên: 03/10/2015, 21:57

... Bearing and raceway wear and tear present initially as general roughness and progresses to metal fatigue, and ultimately spall and chip on the surface of the rolling elements [93] Figure 2.4 and ... energy, magnetic energy, operational thermal stress and harsh environmental conditions e.g., humidity and chemical corrosion, causing wear and tear, and ultimately numerous types of fault may develop ... diagnostic scheme, and the rationale for condition monitoring using MCSA and vibration analysis, and sets the stage for stating the objectives of this research Fault statistics and literature survey...

Ngày tải lên: 04/10/2015, 07:58