molecular design and simulation

... Olivucci (Editor) VOLUME 17 Molecular and Nano Electronics: Analysis, Design and Simulation J.M Seminario (Editor) VOLUME 18 Nanomaterials: Design and Simulation P.B Balbuena and J.M Seminario (Editors) ... NA L C H E M I ST RY Molecular and Nano Electronics:Analysis, Design and Simulation Edited by J M Seminario Department of Chemical Engineering and Department of Electrical and Computer Engineering ... success of molecular and nano-electronics: a theory guided approach to the design of molecular- and nano-electronics The editor thanks all the contributors for their kind collaboration, effort, and...

Ngày tải lên: 04/06/2014, 14:36

... noise, and can be neglected 29 SYSTEM SIMULATIONS 4.1 Introduction System-level simulation combining mechanical and electrical elements is extremely important for MEMS design More specifically, design ... structural layers, which allow novel and flexible design, such as fully differential capacitive sensors, self-actuating springs and gimbaled gyroscope designs[12] Such designs can not be implemented ... buffers and preamplifiers enables isolation of the sensing nodes, preamplification of the signal and provides design flexibility for the later stages In the demodulator and preamplifier design, switched-capacitor...

Ngày tải lên: 27/10/2013, 23:15

... noise, and can be neglected 29 SYSTEM SIMULATIONS 4.1 Introduction System-level simulation combining mechanical and electrical elements is extremely important for MEMS design More specifically, design ... structural layers, which allow novel and flexible design, such as fully differential capacitive sensors, self-actuating springs and gimbaled gyroscope designs[12] Such designs can not be implemented ... buffers and preamplifiers enables isolation of the sensing nodes, preamplification of the signal and provides design flexibility for the later stages In the demodulator and preamplifier design, switched-capacitor...

Ngày tải lên: 22/12/2013, 08:16

Ngày tải lên: 26/01/2014, 07:20

... Engineering (B Braunschweig and R Gani, Editors) Computer Aided Molecular Design: Theory and Practice (L.E.K Achenie, R Gani and V Venkatasubramanian, Editors) Integrated Design and Simulation of Chemical ... new design paradigm designated today by Process Integration Its application relies on the intensive use of Process Simulation Combining design and simulation allows the designer to understand ... criteria and the environment of constraints Computer simulation is the main tool for analysis and synthesis However, the quality and efficiency of the final design depends on the capacity of the designer...

Ngày tải lên: 02/04/2014, 15:49

... Olivucci (Editor) VOLUME 17 Molecular and Nano Electronics: Analysis, Design and Simulation J.M Seminario (Editor) VOLUME 18 Nanomaterials: Design and Simulation P.B Balbuena and J.M Seminario (Editors) ... Carolina Herrera, and Jorge M Seminario Structural Properties of Pure and Binary Nanoclusters Investigated by Computer Simulations 35 Giulia Rossi and Riccardo Ferrando Computer Simulation of the ... C H E M I ST RY Nanomaterials: Design and Simulation Edited by Perla B Balbuena Jorge M Seminario Department of Chemical Engineering and Department of Electrical and Computer Engineering Texas...

Ngày tải lên: 04/06/2014, 14:38

... configuration The simulation and measurement results are presented in Figure 7, 8, and 10 The average deviations between IDEA1 simulations and testbed measurements are 5.2, 3.2, 6.5 and 3.4%, respectively ... 49.3 and 45.8%, respectively The ones between IDEA1_NOHW and NS-2 are 1.0, 2.6, 8.3 and 7.2% Therefore, the average deviation between IDEA1_HW and NS-2 is 26.7%, and the one between IDEA1_NOHW and ... (mainly BO, SO and sample rates) have been studied To investigate the effect of SO and BO, SO is fixed to and BO is set to 0, and 2, which results in a constant active period of 15.36 ms and a superframe...

Ngày tải lên: 20/06/2014, 22:20

... receiver, the parallel active filter consists of a DC-link static power converter and an energy storage element Design and Simulation of a Shunt Active Filter 55 The control circuit performs synthesis ...   ~ p   ~ ur  q  q  u r  ur   and the equivalent three-phase components will be, respectively: 1  p 0     (12) Design and Simulation of a Shunt Active Filter * iFa  * ... Simulink model Fig and show the current waveforms and their harmonic spectrum in case of a non-linear load taken for study, whereas Fig and present the compensated current waveforms and harmonic spectrum...

Ngày tải lên: 06/07/2014, 09:20

... (Logic Elements) and 0RAM bits; 2,085 LEs and 24,576 RAM bits; 1,151LEs and 49,152 RAM bits, respectively IV CO -SIMULATION BASED ON EDA SIMULATOR LINK Based on EDA simulator link, the simulation architecture ... performs the function of speed estimation and speed loop adaptive PI controller, the function of current controller and coordinate transformation (CCCT) and SVPWM, and the function of SMO-based rotor ... of PMSM drive, the sampling frequency is designed with 16kHz, and those in speed loop is 2kHz The clocks with 20ns and 80ns periods are sent to work-1 and work3 of ModelSim A finite state machine...

Ngày tải lên: 02/08/2015, 13:21

Ngày tải lên: 16/03/2014, 08:20

... Rhea, Randall W HF filter design and computer simulation / Randall W Rhea p cm Includes bibliographical references and index ISBN l-884932-25-8 Electric filters Design and construction Electric ... approached from the HF Filter Design and Computer Simulation passband The bandpass response in Figure l-l has passband ripple Because energy not transmitted is reflected, passband attenuation ripple ... of minimal loss in HF Filter Design and Computer Simulation the desired bands and isolation across unwanted frequency bands A multiplexer typically has a common port and a number of frequency diversified...

Ngày tải lên: 31/03/2014, 22:20

Ngày tải lên: 03/07/2014, 22:30

... Verilog memories or large VHDL records can be expanded without any delay – The format of the simulation database is optimized for large designs and long simulation runs File sizes are smaller in comparison ... The simulation results are stored in a simulation database called ASDB (Aldec Simulation Database) The Accelerated Waveform Viewer includes a number of improvements in comparison to the Standard ... 2006 16.3 Simulation Setup By default, the Standard Waveform Editor is used for all simulations, however, it can be replaced by the Accelerated Waveform To so, select the Create ASDB Simulation...

Ngày tải lên: 08/08/2014, 10:21

... Mr H Meier and Mr T Riehl for performing and evaluating a large number of investigations and testings, Mr W Thomala for valuable discussions, Dr G E Totten, Dr K Funatani, Dr L Xie, and Mr R Johnson ... support with photographs and experimental results and finally my family for support with plenty of time during preparing the manuscript REFERENCES Askeland, D.R The Science and Engineering of Materials, ... International Organization for Standardization: ISO 1891: Bolts, screws nuts and accessories—terminology and nomenclature www.iso.ch International Organization for Standardization: ISO 2702: Heat...

Ngày tải lên: 10/08/2014, 12:21

... Fundamentals and Testing: Second Edition, Revised and Expanded, Raymond G Bayer Engineering Design for Wear: Second Edition, Revised and Expanded, Raymond G Bayer Clutches and Brakes: Design and Selection, ... Selection and Application, Duane Tandeske 73 Zinc Handbook: Properties, Processing, and Use in Design, Frank Porter 74 Thermal fatigue of Metals, Andrzej Weronski and Tadeusz Hejwowski 75 Classical and ... H Bell 17 Gears and Their Vibration:A Basic Approach to Understanding Gear Noise, J Derek Smith 18 Chains for Power Transmission and Material Handling: Design and Applications Handbook,American...

Ngày tải lên: 10/08/2014, 12:21

... conditions and so on The accuracy of predicted mechanical properties is satisfactory It is noted that these models should be widely used for off-line simulation of designing steel compositions and processing ... All Rights Reserved 2 Design Simulation of Kinetics of Multicomponent Grain Boundary Segregations in the Engineering Steels Under Quenching and Tempering Anatoli Kovalev and Dmitry L Wainstein ... condition and on-line simulation for guaranteeing mechanical properties of steels REFERENCES Proceedings of International Conference on Physical Metallurgy of Thermomechanical Processing of Steels and...

Ngày tải lên: 10/08/2014, 12:21

... per atom divided by Boltzmann constant; W0 and W00 are the mixing energies in solid and liquid states; Xs and Xl are the impurity concentration in solid and liquid phases at the temperature T Solving ... constant independent of both temperature and C Xa (0); R is the gas constant and T is the temperature Influence of C and alloying elements on parameters Q, K, and n in Eq (31) is determined for various ... of I and M: DGI ¼ DG0 þ I bb ba MI b YM À MI Xa Cb Ca M ð19Þ bb ba MI b YI À MI Xa ab aa I ð20Þ DGM ¼ DG0 þ M where Cb and ab are the fractions of sites available in the interface for I and M...

Ngày tải lên: 10/08/2014, 12:21

... steel cooling is given in Tables and and shown in Fig 41 The cooling curve is approximated partially by a constant function and at the individual time intervals Dt and the rate of decomposition ... a better understanding of processing operations and optimize processes with a view to improving quality and reducing production costs By using this technique, residual stress and distortion in ... metallurgical process also can be predicted; hence some useful theory and simulation methods can be proposed and introduced in the simulations of various metallurgical processes [19–23] From these...

Ngày tải lên: 10/08/2014, 12:21

... elastic–viscoplastic solids and viscous fluids to apply simulation of the casting process was proposed and verified by experimental and numerical results On the other hand, a proposal based on the ... find this steady solidification profile and the distribution of temperature and fluid velocities in both the liquid phase and the solid phase On the other hand, due to the symmetry to the central ... slab is mm, and two casting speeds are used Vc ¼ 400 and 600 mm=sec Calculated Results Simulated results of steady temperature field both in the strip and roll is shown in Fig 44(a) and (b) for...

Ngày tải lên: 10/08/2014, 12:21

... 375–381 Ju, D.Y.; Inoue, T In Simulation of Solidification and Thermo-mechanical Behavior in Continuous Casting Process, Modeling and Simulation in Metallurgical Engineering and Materials Science; Yu, ... simulation results The unified inelastic constitutive equation may describe the stress and deformation in the whole region of the solidifying process including liquid and solid state In the simulation ... with calculated results and experimental data for temperature, distortion and residual stress in these metallurgical processes, the metallo-thermo-mechanical theory and simulation method proposed...

Ngày tải lên: 10/08/2014, 12:21