Xếp hình hộp 4 góc ppt

Ngày tải lên: 11/07/2014, 03:20

... book dates from 17 34 and thus this model is older than that. When you have finished this modular box you may open it from any side. 1 Divide in three in both directions 2 3 4 Cut along the bold

Ngày tải lên: 11/07/2014, 03:20

... ÿ✁ ✄✂✆☎✆✝✄✝✟✞✡✠☞☛✍✌✏✎✒✑✔✓✕✌✖✑✔✌✗✝✙✘✚✑✜✛✢✛✕✣✥✤✧✦★✠☞✛✩✝✍✪✬✫✬✭✍✣✥✮✯✣✰✓✕✌✗✝✱✓✩✲✥✑✜✎✳✣✔✝✵✴✏☛✗✪✶✓✢✌✍✷✸✣✺✹✱✓✩✪✶✎✯✓✢✌✍✷✧✲✻✮✯✣✔✑✚✪✶✣✔✪✻✂✗✼✽✭✍✣ ✝✱✓✩✪✶✎✾✑✜✌✗✲✁✣❀✿✗✣✥✎❁✫✽✣✺✣✥✌❂✎❁✫✽✠✧✘✚✑✜✛✢✛✕✣✥✤❃✦★✠☞✛❄✝✄✪✽✓❄✪✽✠☞✌✄✣❅✭❆✑✜✛❇✦❈✠✜✦❉✎✯✭✍✣❀✫✬✓❄✝✏✎✯✭❊✂✵❋●✭✍✣❍✲❏■❃✎✯✭✍✣❀✌✏☛✍✞❃✿❑✣✺✮✽✠✜✦ ✲✁✮✳✣✔✑☞✪❁✣✔✪✽✠☞✎✳✭✍✣✥✮✳✫✬✓❄✪✶✣❀✎✳✭✍✣✥✮✯✣❀✫✬✓✢✛✕✛✵✌✄✠☞✎▲✿❑✣❀✣✥✌✄✠☞☛✍✷✚✭◆▼✗✑✔▼❑✣✺✮❖✦★✠✚✮▲◗✑☞✲✒■✵✂ ÿ✥❘✏✂❅❋●✛✢✠◗✪✶✣❀✎✳✭✍✣❀✛❄✑✥✤◗✣✥✮✒✪...

Ngày tải lên: 09/12/2013, 16:15

... result. Repeat Steps 24- 28 on the right side. 30. Pull the uppermost, double-thickness top layer to the right to expose the hidden layer beneath. The paper will not lie flat. 24- 28 x1 31. Bisect ... of the colored flap to the outer edge. 14. The result. The first small preliminary base should lay perfectly between the edges and the center, forming 1 /4 of the larger one (made in Step 12...

Ngày tải lên: 09/12/2013, 16:15

... Dahlia Maarten van Gelder  1985 Nov 1 2 3 4 5 6AReverse fold in the center to fold both ends up

Ngày tải lên: 09/12/2013, 16:15

... along the vertical with a mountain-fold to facilitate the tuck. Then flatten out to secure. ONE 24. Finished. $ “One-Way” Arrow (continued) Copyright 1998-99 Stephen Hecht. All Rights Reserved 12. ... raw edges from behind. Model is not flat at the “point” end. 13. Reverse-fold. Repeat on left. 14. Swing down. 15. Wrap a single ply around the central trapezoid. Easier if you open the model...

Ngày tải lên: 10/12/2013, 11:16

... 12 on the other side of the model. Reverse fold the flap sticking up on each side into the model. 14 Now to finish the model, you make an accordion fold on the front of the Jump Ant to form the head. ... Jonathon who I have not heard from in many years, but who remains in my heart and in my thoughts. 1 2 3 4 Cupboard fold the sides to the center of the model. Mountain fold the top layer o...

Ngày tải lên: 10/12/2013, 11:16

... the sides to the middle to thin the model down. Reapeat on all sides, that is three more times 4 Yet another model that should only be made from foil paper!

Ngày tải lên: 10/12/2013, 11:16

... lengthwise then cut it in half at the crease. Giving an approx. piece of 10.9cmx6.2cm or there about. 3 4 5 Valley fold at the place where the diagonal fold meets the outside horizonatal folds, first ... additional creases shown here, this will give you an even smaller square in the center. 6 11 12 13 14 Swivel fold the leg under to the right. Swivel fold a leg over to the right. The legs...

Ngày tải lên: 10/12/2013, 11:16

... 19 20 21 22 Bebé Stegosaurus Fernando Gilgado Gómez 1 2 4 7 8 5 6 3

Ngày tải lên: 10/12/2013, 12:15