Tài liệu Lab 5 1 3 Connecting Router LAN Interfaces pdf

... 1 - 2 CCNA 1: Networking Basics v 3. 0 - Lab 5. 1. 3 Copyright  20 03, Cisco Systems, Inc. Lab 5. 1. 3 Connecting Router LAN Interfaces Objective ... Locate one or more RJ 45 connectors on the router labeled 10 /10 0 Ethernet”. This identifier may vary depending on the type of router used. A 250 0 series router will have an AUI DB 15 Et...

Ngày tải lên: 24/01/2014, 19:20

... Lab 5. 2.3a Connecting Router LAN Interfaces Objective • Identify the Ethernet or Fast Ethernet interfaces on the router • Identify and locate the proper cables to connect the router ... Ethernet 10 /10 0 NIC installed • One Ethernet switch or hub • One router with an RJ- 45 Ethernet or Fast Ethernet interface or an AUI interface • 10 BASE-T AUI transceiver...

Ngày tải lên: 11/12/2013, 14:15

... 1 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 5. 1. 3 Copyright  20 03, Cisco Systems, Inc. Lab 5. 1. 3 Using the Boot System Command Objective ... this lab. Perform those steps on all routers in this lab assignment before continuing. 2 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 5. 1. 3 Copyright  20 03, Cisco Systems, Inc. Step 1 ......

Ngày tải lên: 18/01/2014, 04:20

... 1 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 5. 1. 3 Copyright  20 03, Cisco Systems, Inc. Lab 5. 1. 3 Using the Boot System Command Objective ... designation Router name Enable secret password Enable/VTY/ and Console passwords Router 1 AD class cisco 2 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 5. 1. 3 Copyright  20 03, Cisc...

Ngày tải lên: 18/01/2014, 04:20

... are connected to a router. Computer IP Address Subnet mask Default Gateway PC – A 19 2 .16 8 .1. 1 255 . 255 . 255 .0 Not Required PC – B 19 2 .16 8 .1. 2 255 . 255 . 255 .0 Not Required Step 5 Access the Command ... 1 - 4 CCNA 1: Networking Basics v 3. 0 - Lab 5. 1. 13b Copyright  20 03, Cisco Systems, Inc. Lab 5. 1. 13b Building a Switch-based Network Objective...

Ngày tải lên: 11/12/2013, 14:15

... Amsterdam, DLCI 3 01, Contact Peter Muller (+ 31 20 6 23 32 67) Circuit #KPN4 655 55 Berlin(config-if)#ip address 19 2 .16 8 .5. 2 255 . 255 . 255 .0 Berlin(config-if)#frame-relay interface-dlci 3 01 Berlin(config-if)#interface ... Voight( +33 -1 -55 34 -2 234 ) Circuit #FRT372826 Amsterdam(config-if)#ip address 19 2 .16 8.4 .1 255 . 255 . 255 .0 Amsterdam(config-if)#frame...

Ngày tải lên: 11/12/2013, 14:15

... to the Gadsden Router is: IP Address 19 2 .16 8 .14 .2 IP subnet mask 255 . 255 . 255 .0 Default gateway 19 2 .16 8 .14 .1 Step 3 Login to the router in user mode a. Connect to the Gadsden router and login. ... should be similar to the following: Mon Sep 16 14 :10 :08 2002: Receiving ‘startup-config’ file from 19 2 .16 8 . 13 .1 in binary mode Mon Sep 16 14 :11 :14 20...

Ngày tải lên: 11/12/2013, 14:15

... v 3. 0 - Lab 5. 2 .3 Copyright  20 03, Cisco Systems, Inc. Router Clocking S0 Interface IP Address Subnet mask Router – A DCE 19 2 .16 8 .3 .1 255 . 255 . 255 .0 Router – B DTE 19 2 .16 8 .3. 2 255 . 255 . 255 .0 ... the routers to route packets between local area networks 19 2 .16 8 .1. 0 and 19 2 .16 8.2.0. Router E0 Interface IP Address Subnet mask Router – A 19 2...

Ngày tải lên: 11/12/2013, 14:15

... 1 - 2 CCNA 1: Networking Basics v 3. 0 - Lab 5. 1. 4 Copyright  20 03, Cisco Systems, Inc. Lab 5. 1. 4 RJ- 45 Jack Punch Down Objective • Learn the ... also cuts off any extra wire. CAT 5 or CAT 5e cabling and CAT 5 or 5e rated T568-B jacks will be used. A CAT 5/ 5e straight- wired patch cable with an RJ- 45 connector will normally plug into ... required: • 60 -...

Ngày tải lên: 24/01/2014, 19:20

... 1 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 5. 1 .5 Copyright  20 03, Cisco Systems, Inc. Lab 5. 1 .5 Troubleshooting Configuration Register ... reload the router a. Enter global configuration mode and enter the following commands: Router& gt;enable GAD#configure terminal 3 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 5. 1 .5 Copyright .....

Ngày tải lên: 24/01/2014, 19:20